With the development kit, you get a license for the Efinity^® software with 1 year of upgrades.
The Efinity software provides a complete tool flow from RTL design to bitstream generation, including synthesis, place-and-route, debugging, and timing analysis.

• Efinix Ti180J484C4 FPGA in a 484-ball FineLine BGA package
• 8 Gbit (256 Mbit x 16 x 2 channels) LPDDR4 or LPDDR4x SDRAM:
  • Supports x32 data width
  • Read/write speed up to 3.0 Gbit/s
• 2 x 256 Mbit SPI NOR flash memory
  • Supports single, dual and quad modes for each SPI flash
  • Supports x8 with both SPI flash memories in quad mode
• 4 x QSE connectors
  • 2.5 Gbit/s Tx/RX hardened MIPI interfaces
• Micro SD card slot
• FPGA mezzanine card (FMC) with low pin count connection (LPC)
• USB Type C port for configuring the development board
• 25, 33.33, 50 and 74.25 MHz oscillators for Ti180 PLL input
• User LEDs and switches:
  • 6 LEDs
  • 2 pushbutton switches
• Power:
  • 12V power supply connector
  • On-board regulator sources: 0.62 V, 0.85 V, 0.95 V, 1.1 V, 1.2 V, 1.8 V, 3.3 V, 5.0 V
• Power good and Ti180 configuration done LEDs

• Titanium Ti180 J484 development board preloaded with a demonstration design
• Raspberry Pi v2 camera module (with 15-pin flat cable)
• Dual Raspberry Pi camera connector daughter card
• 2 IMX477 camera connector daughter cards
• Coral camera connector daughter card
• FMC to QSE adapter card
• Daughter card with HDMI connector
• Ethernet connector daughter card
• MIPI and LVDS expansion daughter card
• 2 22-pin flat cables
• USB type C cable
• 12 V, 5 A universal power supply
• Heat sink
• 14 standoffs, 10 screws and 14 nuts